This is an ODT (introduction only) paraffin pack with a low melting point that can be used to make thickness well even for those who are new to paraffin technology. It can also be used on delicate and prone to dryness, eyelids and lips. The heating and sealing effects of paraffin allow the introduction essence that blends into the skin as a base penetrates into the skin. In addition, the effect of paraffin is to promote the secretion of sweat and sebum, which can result in the removal of dirt. [How to use] 1) Cleanse the skin before introducing the agent. 2) The introduction agent can be either oil-soluble or water-soluble ingredients. 3) Protect with plastic wrap along the face line to hide the hairline at the hairline. 4) Using a melting unit (melting equipment), separate about 2 small balls from it and set it to an appropriate temperature of about 41°C. 5) The practitioner makes two oval-shaped eye pads in advance and places them on top of the eyes. Then apply paraffin from the contour to fix the wrap and skin. Except for the lips, apply slowly from the forehead (about 38°C), and finally apply the lips carefully. 6) After making sure there is no residual coating, apply about 1 cup of paraffin to increase heat retention and sealing. Apply paraffin at about 46°C evenly until the skin color is white enough to show through. It's primed, so it's okay if it's a little hot. 7) Ideally, the weight of paraffin should be about 60g to 80g when removed from the face. 8) When you are done, wrap the nostrils with plastic wrap. 9) Aim for about 20 minutes from the start of application, then remove while floating around. Remove the small parts that are difficult to remove while moving them up and down in detail. And finally, wipe it off with a wet cotton pad and a hot towel.