[Dharma sticker] 「FUCK THE WORLD DRIVE SAFE」 the world. But just drive seriously. A unique sticker filled with poisonous tongues and safety prayers on the strong face of traditional Daruma. From flashy custom cars to austere old cars, motorcycles, PCs, and tool boxes. No matter where you put it, it has a strong presence. Top: Bold "THE WORLD DRIVE SAFE" Bottom: Traditional amulet character "Safe Traffic" It's Japanese-style, but it's full of street feel. My eyes are staring sharply. Size: 105mm (Height) × 98mm (Width) A loving curse from Daruma, "Drive safely." A unique presence that can be conveyed to the drivers around him in one shot. "Ordinary stickers are not enough." This is one of the determinations that I want such a person to put on. Size: Length 105mm Width 98mm It will be a cutting sticker sticker. Please apply slowly and carefully. ●How to apply cutting stickers (step by step)● (1) Clean the surface to be pasted! Wipe the surface you want to apply (glass, car body, wall, etc.) thoroughly with mild detergent or alcohol to completely remove dust, oil, and dirt. Moisture should be thoroughly dried. If stains remain, the sticker will easily float or peel off, so it is important to do this carefully. (2) Check the location in advance! Lift the sticker slightly off the mount along with the transfer sheet and align it with the actual position to be attached. It is recommended to lightly temporarily stop it with masking tape and determine its position. (3) Remove the sticker from the mount! If a transfer sheet (transparent film) is attached, slowly remove the transfer sheet from the mount. Be careful not to tear small parts or fine lines. (4) Stick from the center to the outside! Place the transfer sheet on the object and apply it from the center to the outside with a card or squeegee (hard card is acceptable) while pushing out the air. Don't apply it all at once, but proceed little by little to prevent air bubbles from entering. (5) Remove the transfer sheet! After making sure that the sticker is firmly attached, slowly peel off the transfer sheet at an angle of about 45 degrees. When the sticker floats together, put it back and press it again, make it stick firmly, and try again. ●Finishing points after completion● • If air bubbles get in, make a small hole with a pin or needle to release the air and gently push it out with your fingers. • Do not wash with water or rub vigorously for 24 hours immediately after application (until the adhesion is stable). • If you are using outdoor stickers, avoid direct sunlight and high temperatures and humidity to ensure they last longer. Please note ▼There are some individual differences. Please note that the size is an estimate. ▼ Regarding the color scheme, there may be slight differences due to the performance of the monitor and digital camera.